Optimalizace zdvihacího mechanismu nůžkového stolu – Bc. David KÁROLY
Bc. David KÁROLY
Master's thesis
Optimalizace zdvihacího mechanismu nůžkového stolu
Optimization of lifting mechanism of the scissor table
Abstract:
Diplomová práce obsahuje informace o technickém návrhu a optimalizaci zdvihacího mechanismu nůžkového stolu. V práci jsou uvedeny odborné vztahy potřebné k návrhu nůžkového stolu. Poté jsou zde vytvořeny tři varianty optimalizace. Z těchto variant je vybrána ta nejvhodnější a pro tu je provedena detailní analýza.Abstract:
Diploma thesis contains information about technical design and optimalization of lifting mechanism for scissor table. This work presents professional relationships needed to design of scissor table. Then there are made three optimalization variants. From these variants is selected the most appropriate variant and for that option is made a detailed analysis.
Language used: Czech
Date on which the thesis was submitted / produced: 2. 6. 2017
Accessible from:: 31. 12. 2999
Thesis defence
- Supervisor: Doc. Ing. Václav Vaněk, Ph.D.
Citation record
The right form of listing the thesis as a source quoted
KÁROLY, David. Optimalizace zdvihacího mechanismu nůžkového stolu. Plzeň, 2017. diplomová práce (Ing.). ZÁPADOČESKÁ UNIVERZITA V PLZNI. Fakulta strojní
Full text of thesis
Accessibility: Autor si nepřeje zpřístupnění práce veřejnosti
Contents of on-line thesis archive
Published in Theses:- Soubory jsou nedostupné.
Other ways of accessing the text
Institution archiving the thesis and making it accessible: ZÁPADOČESKÁ UNIVERZITA V PLZNI, Fakulta strojníVázaný výtisk práce naleznete v Univerzitní knihovně ZČU, více na http://www.knihovna.zcu.cz/kvalifikacni-prace/
University of West Bohemia
Faculty of Mechanical EngineeringMaster programme / field:
Mechanical Engineering / Design of Manufacturing Machines and Equipment
Theses on a related topic
-
Analýza a porovnání vybraných Free a Profi CAD programů z pohledu uživatele znalého 2D konstruování
Tomáš Douda -
Aplikace CAD/CAM softwaru PowerMILL 2020 při reverzním inženýrství
Tomáš Rais -
Aplikace CAD/CAM softwaru při obrábění
Lukáš Havran -
Metodika přípravy učitele na výuku strojírenských předmětů s využitím systémů CAD
Martin Kunc -
Návrh konstrukce a technologického postupu výroby flobertky ráže 4mm s využitím CAD a CAM softwarů
Karel Řezníček -
Výroba modelového zařízení pro součást "Těleso" s využitím CAD/CAM software v
Jiří Gulda -
Aplikace CAD/CAM softwaru EdgeCAM při obrábění
Vojtěch Trčka -
Využití CAD/CAM systému UNIGRAPHICS při obrábění složitých tvarových ploch
Pavel RUDA