Zvyšování užitných vlastností AM dílů pomocí tenkých vrstev – Bc. Zdeněk ŠÁLEK
Bc. Zdeněk ŠÁLEK
Master's thesis
Zvyšování užitných vlastností AM dílů pomocí tenkých vrstev
Increasing the useful properties of AM parts using thin layers
Abstract:
Tato práce se zabývá návrhem pístu pneumatické očišťovací pistole a zvýšení jeho užitných vlastností pomocí tenké vrstvy. Vzorky podstoupily tepelné zpracování žíháním a vytvrzením a následně byly deponovány tenkou vrstvou TiAlSiN. Vzorky se zanalyzovaly z hlediska mikrostruktury, chemického složení, tvrdosti substrátu a nano tvrdosti vrstvy. Následně byly pomocí tribologické analýzy porovnány koeficienty …moreAbstract:
This paper deals with the design of the piston of a pneumatic cleaning gun and the increase of its useful properties by means of a thin layer. The samples underwent heat treatment by annealing and curing and were subsequently deposited with a thin layer of TiAlSiN. The samples were analysed for microstructure, chemical composition, substrate hardness and nano layer hardness. Subsequently, the coefficients …more
Language used: Czech
Date on which the thesis was submitted / produced: 28. 5. 2021
Accessible from:: 31. 12. 2999
Thesis defence
- Supervisor: Ing. Ivana Zetková, Ph.D.
Citation record
The right form of listing the thesis as a source quoted
ŠÁLEK, Zdeněk. Zvyšování užitných vlastností AM dílů pomocí tenkých vrstev. Plzeň, 2021. diplomová práce (Ing.). ZÁPADOČESKÁ UNIVERZITA V PLZNI. Fakulta strojní
Full text of thesis
Accessibility: Autor si nepřeje zpřístupnění práce veřejnosti
Contents of on-line thesis archive
Published in Theses:- Soubory jsou nedostupné.
Other ways of accessing the text
Institution archiving the thesis and making it accessible: ZÁPADOČESKÁ UNIVERZITA V PLZNI, Fakulta strojníVázaný výtisk práce naleznete v Univerzitní knihovně ZČU, více na http://www.knihovna.zcu.cz/kvalifikacni-prace/
University of West Bohemia
Faculty of Mechanical EngineeringMaster programme / field:
Machining, Additive Technology and Quality Assurance / Machining, Additive Technology and Quality Assurance
Theses on a related topic
-
3D tisk pro odlehčené strukturní díly vozidel
Filip Klejch -
Optimalizace procesních parametrů aditivní technologie L-PBF
Dominik Zdráhal