Petr CHYLÍK
Bachelor's thesis
Návrh těhlice vozu Formula SAE
Upright for car of Formula SAE
Abstract:
Tato bakalářská práce se zabývá konstrukčním návrhem přední a zadní těhlice závodního vozu kategorie Formula Student. Součástí je nejprve krátká rešerše v oblasti soutěže Formula Student a konstrukcí těhlic. Dále obshauje volbu a výpočet ložisek, samotný návrh těhlic a následnou volbu materiálu. Závěrem je zde uvedena kontrolní simulace návrhů pomocí MKP analýzy.Abstract:
This thesis deals with construction concept of front and rear uprights of the Formula Student category. The first component is a short research on Formula Student competition and upright design. Thesis also mentions selection and calculation of bearings, the upright design including choice of materials. Finally, there is shown a simulation of design using FEM analysis.
Language used: Czech
Date on which the thesis was submitted / produced: 20. 5. 2016
Accessible from:: 31. 12. 2999
Thesis defence
- Supervisor: Doc. Ing. Martin Hynek, Ph.D.
Citation record
The right form of listing the thesis as a source quoted
CHYLÍK, Petr. Návrh těhlice vozu Formula SAE. Plzeň, 2016. bakalářská práce (Bc.). ZÁPADOČESKÁ UNIVERZITA V PLZNI. Fakulta strojní
Full text of thesis
Accessibility: Autor si nepřeje zpřístupnění práce veřejnosti
Contents of on-line thesis archive
Published in Theses:- Soubory jsou nedostupné.
Other ways of accessing the text
Institution archiving the thesis and making it accessible: ZÁPADOČESKÁ UNIVERZITA V PLZNI, Fakulta strojníVázaný výtisk práce naleznete v Univerzitní knihovně ZČU, více na http://www.knihovna.zcu.cz/kvalifikacni-prace/
University of West Bohemia
Faculty of Mechanical EngineeringBachelor programme / field:
Mechanical Engineering / Transport Vehicles and Handling Machinery
Theses on a related topic
-
Optimalizovaný návrh podlahy závodního vozu kategorie FSAE z hlediska aerodynamiky
Matěj LINHART -
Návrh variabilní těhlice pro FSAE
Jakub Měsíček -
Návrh a měření dynamických vlastností prvků uložení motoru první generace FSAE
Marek Láníček -
Vývoj deformačního členu pro vůz FSAE
Martin KOCOUREK -
Návrh převodovky pro závodní vozidlo
Jan Horák -
Konstrukční návrh mechanické části elektromotoru a těhlice pro kolovou skupinu vozu Formule Student
Martin ŠANTORA