Trvanlivost řezného nástroje při obrábění plastů – Bc. Martina MALACHOVÁ
Bc. Martina MALACHOVÁ
Master's thesis
Trvanlivost řezného nástroje při obrábění plastů
Durability of a cutting tool during cutting of the plastics
Abstract:
Diplomová práce se zabývá problematikou trvanlivosti řezného nástroje při obrábění plastů. Při třecích zkouškách na hrotovém soustruhu S32 se používala čtyřbřitá fréza o {\o} 8 mm, obrobkem byl váleček z polypropylenu. Naměřené výsledky byly porovnány s výsledky třecích zkoušek pro kov za stejných podmínek. Následně byly provedeny třecí zkoušky pro obrobek z keramiky. Dále se pomocí frézky FC 16 CNC …moreAbstract:
This master thesis concentrates on durability of a cutting tool during cutting of the plastics. A centre lathe S32 and a four toothed milling cutter {\o} 8 mm were used for the frictional tests. A work piece was made from polypropylene. The observed results were compared with the results of the frictional tests for a metal when the conditions of processing were the same. Next the frictional test was …more
Language used: Czech
Date on which the thesis was submitted / produced: 30. 5. 2006
Identifier:
3007
Thesis defence
- Date of defence: 6. 6. 2006
Citation record
The right form of listing the thesis as a source quoted
MALACHOVÁ, Martina. Trvanlivost řezného nástroje při obrábění plastů. Zlín, 2006. diplomová práce (Ing.). Univerzita Tomáše Bati ve Zlíně. Fakulta technologická
Full text of thesis
Accessibility: Autor si přeje zpřístupnit práci pouze na univerzitě až od 28. 05. 2013
Contents of on-line thesis archive
Published in Theses:- autentizovaným zaměstnancům ze stejné školy/fakulty
Other ways of accessing the text
Institution archiving the thesis and making it accessible: Univerzita Tomáše Bati ve Zlíně, Fakulta technologickáPlný text práce je k dispozici v elektronické podobě.
Tomas Bata University in Zlín
Faculty of TechnologyMaster programme / field:
Process Engineering / Technological Equipment Construction
Theses on a related topic
-
Nástrojové materiály a jejich efektivní využití
Luboš Crhan -
Příspěvek k obrábění Ni superslitiny a hodnocení řezivosti vybraných řezných materiálů
Tomáš Zlámal -
Rozbor soustružnických nástrojů s VBD pro aplikaci proměnné hloubky řezu
Jakub Pekr -
Stanovení vlivu hrubovacích operací na dokončovací pro technologii frézování
Tomáš Močička -
Zjišťování vlivu procesních kapalin z firmy PARAMO, a.s. na technologii vrtání a jakost obrobeného povrchu při vrtání slitiny hliníku
Josef Hurský -
Zjišťování vlivu řezných podmínek na jakost obrobeného povrchu při vrtání
Jan Paliculin -
Vliv strategie obrábění na jakost povrchu při CNC frézování
Adam MÁČALA -
Posouzení vlivu tuhosti stroje na drsnost obrobku
David Preisler