Vliv opotřebení na objem odebraného materiálu – Bc. Tomáš BLUMENTRIT
Bc. Tomáš BLUMENTRIT
Master's thesis
Vliv opotřebení na objem odebraného materiálu
Influence of tool wear on volume of material removed
Abstract:
Diplomová práce se zabývá vlivem opotřebení na objem odebraného materiálu. Práce obsahuje základní informace o čelním frézování a frézování slitin na bázi niklu, opotřebení břitu, vzniku třísky a tepelné bilanci. V práci je zpracován experiment vlivu opotřebení na objem odebraného materiálu a rozbor vzniklých třísek. Opotřebení má vliv na objem odebraného materiálu, což bylo potvrzeno výsledky experimentu …moreAbstract:
The diploma thesis deals with the influence of tool wear on the volume of material removal rate. The thesis contains basic information about face milling and milling of nickel-based alloys, tool wear, chip formation and heat balance. In the thesis was carried out an experiment of the tool wear on the volume of material removal rate and an analysis of the resulting chips. Tool wear affects the volume …more
Language used: Czech
Date on which the thesis was submitted / produced: 31. 7. 2020
Accessible from:: 31. 12. 2999
Thesis defence
- Supervisor: Doc. Ing. Miroslav Zetek, Ph.D.
Citation record
The right form of listing the thesis as a source quoted
BLUMENTRIT, Tomáš. Vliv opotřebení na objem odebraného materiálu. Plzeň, 2020. diplomová práce (Ing.). ZÁPADOČESKÁ UNIVERZITA V PLZNI. Fakulta strojní
Full text of thesis
Accessibility: Autor si nepřeje zpřístupnění práce veřejnosti
Contents of on-line thesis archive
Published in Theses:- Soubory jsou nedostupné.
Other ways of accessing the text
Institution archiving the thesis and making it accessible: ZÁPADOČESKÁ UNIVERZITA V PLZNI, Fakulta strojníVázaný výtisk práce naleznete v Univerzitní knihovně ZČU, více na http://www.knihovna.zcu.cz/kvalifikacni-prace/
University of West Bohemia
Faculty of Mechanical EngineeringMaster programme / field:
Mechanical Engineering / Manufacturing Processes - Technology of Metal Cutting
Theses on a related topic
-
Efektivní frézování slitin na bázi niklu monolitními nástroji z řezné keramiky
Martin Vydomus -
Vliv geometrie na trvanlivost řezného nástroje v průběhu vysokorychlostního frézování titanových slitin
Michal Jurčík -
Možnosti frézování niklových slitin
Miroslav Janoš -
Vysokoposuvové frézování hliníkových a titanových slitin
Martin Gazda -
Technologie vysokoposuvového frézování titanových slitin
Vlastimil Juřica -
Moderní materiály pro řezné nástroje a obrábění materiálu P91
Rostislav Hluchník -
Experimentální mechanická analýza konstrukčního LSL kompozitu ze směsi plochých třísek vybraných druhů dřevin
Michal Šulák -
Design briketovacího lisu kovových třísek
Adéla Matušková