Jan KASKA
Bachelor's thesis
Návrh a optimalizace induktoru pro indukční pájení
Design and optimization of inductor for induction brazing
Abstract:
Bakalářská práce se zabývá problémem optimalizace induktoru pro indukční pájení měděné vsázky. Nejprve je provedena důkladná rešerše technologií využívaných pro indukční tvrdé pájení mědi, jež reflektuje poznatky z praxe i aktuální trendy a výzkumy. V další části je definován konkrétní problém, kterým se tato práce zabývá, a jsou zde upřesněny parametry jednotlivých komponent. Dále je popsán matematický …moreAbstract:
The goal of this bachelor thesis is to optimize inductor for induction brazing of copper tubes. The first objective is to create thorough research of technologies used for induction brazing of copper, including practice knowledge, current trends and science research. The next chapter defines the specific problem that this work deals with and the parameters of each component are specified here. In the …more
Language used: Czech
Date on which the thesis was submitted / produced: 7. 6. 2017
Accessible from:: 31. 12. 2999
Thesis defence
- Supervisor: Ing. David Pánek, Ph.D.
Citation record
The right form of listing the thesis as a source quoted
KASKA, Jan. Návrh a optimalizace induktoru pro indukční pájení. Plzeň, 2017. bakalářská práce (Bc.). ZÁPADOČESKÁ UNIVERZITA V PLZNI. Fakulta elektrotechnická
Full text of thesis
Accessibility: Autor si nepřeje zpřístupnění práce veřejnosti
Contents of on-line thesis archive
Published in Theses:- Soubory jsou nedostupné.
Other ways of accessing the text
Institution archiving the thesis and making it accessible: ZÁPADOČESKÁ UNIVERZITA V PLZNI, Fakulta elektrotechnickáVázaný výtisk práce naleznete v Univerzitní knihovně ZČU, více na http://www.knihovna.zcu.cz/kvalifikacni-prace/
University of West Bohemia
Faculty of Electrical EngineeringBachelor programme / field:
Electrical Engineering and Informatics / Electrical and Power Engineering
Theses on a related topic
-
Analýza možnosti náhrady technologie pájení technologií laserového svařování trubkovnic z Cu slitin
David STARKBAUM -
Indukční pájení trubkových rozvodů z vysokolegovaných ocelí
Václav Dobeš -
Konstrukční řešení strojního zařízení pro indukční pájení
Pavel Rec -
Indukční ohřev těles se silně zakřivenými plochami
Ondřej VITOUŠ -
Porovnání plamenného a indukčního ohřevu při tvrdém pájení slitiny AlSi12
David RÝGL -
Problémy při tvrdém pájení tepelného výměníku hliníkovou pájkou
Michal Rychlý -
Simulace nestacionárního radiačního ohřevu skořepinových forem
Martin Hušek -
Numerická simulace indukčního ohřevu ložisek
Zbyněk Havlák