Návrh robotické ruky s využitím aditivní výroby – Bc. Matej Krupčiak
Bc. Matej Krupčiak
Master's thesis
Návrh robotické ruky s využitím aditivní výroby
Design of a Robotic Hand Using Additive Manufacturing
Abstract:
V dnešnej dobe existuje veľké množstvo ľudí, ktorí, bohužiaľ, v rôznych kritických situá-ciách nevyviazli bez zranenia či inej ujmy na zdraví. Jedna z dôležitých častí tela, o ktorú ľudia v dôsledku či už nehody alebo zo zdravotných príčin prichádzajú, je ruka. Vďaka pok-ročilým technológiám, ktoré dnešný svet ponúka, už nie je také nákladné náhradnú končatinu vyrobiť aj v domácich podmienkach. Pomocou …moreAbstract:
Nowadays, there are lots of people who, unfortunately, did not escape various critical situa-tions without injuries. One of the most important parts of the body that people often lose in accidents is the arm. Thanks to advanced technologies that are available in the modern world, it is not so difficult to create a limb surrogate even at home. Using additive manufacturing and 3D design will enable you …more
Language used: Czech
Date on which the thesis was submitted / produced: 19. 5. 2022
Thesis defence
Citation record
The right form of listing the thesis as a source quoted
Krupčiak, Matej. Návrh robotické ruky s využitím aditivní výroby. Zlín, 2022. diplomová práce (Ing.). Univerzita Tomáše Bati ve Zlíně. Fakulta aplikované informatiky
Full text of thesis
Contents of on-line thesis archive
Published in Theses:- autentizovaným zaměstnancům ze stejné školy/fakulty
Other ways of accessing the text
Institution archiving the thesis and making it accessible: Univerzita Tomáše Bati ve Zlíně, Fakulta aplikované informatikyPlny text prace je k dispozici v elektronicke podobe
Tomas Bata University in Zlín
Faculty of Applied InformaticsMaster programme / field:
Automatické řízení a informatika v průmyslu 4.0 / Automatic Control and Informatics in Industry 4.0
Theses on a related topic
-
Zavedení aditivní výroby (3D tisku) do výuky na základní škole
Petronela Staňová -
Tvorba série 3D reklamních předmětů v rámci realizace autorské vizuální identity
Zuzana Hrušovská -
Zavedení aditivní výroby (3D tisku) do výuky na základní škole
Petronela Staňová -
Vplyv 3D technológií na proces tvorby designu.
Jakub Hrdina -
Robotická ruka na platformě Arduino
Tomáš Makyča -
Příprava výukových materiálů pro ovládání robotické ruky značky Merkur pomocí platformy Arduino
Josef Nuhlíček -
Konstrukce alternativního ovládání robotické ruky Arexx RA-1 Pro pomocí jednodeskového mikrokontroleru Arduino
Štěpán MUDRA -
ROBOTICKÁ RUKA OVLÁDANÁ BEZDRÁTOVOU RUKAVICÍ
Lukáš Holeka